Product Description
High heat 15mm blade
Choose the blade to suit the purpose. These blades are designed so that heat is concentrated along the cutting edge in order to achieve the optimum cutting temperature. Prior to insertion in the material to be cut, the temperature of the blades will be between 100°C and 800°C, depending on the type of blade and the thermocutter used. The temperature to the blade cools down as it enters the material. The temperature depends on the thermal properties and heat conductivity of the material being cut and determines the cutting speed. The cutting edge is evenly heated because of the design of the blade's cutting flanges.
Blades with model numbers in green are only for use with the ZETZ24 and ZETZ25 Thermocutters.
Examples of uses for blade DPM10
Cutting and deburring of:
- Natural and synthetic rubber
- Rubber sheets 30-80 Shore
- Rubber with textile
- PVC boards, foils and sheets
- Cutting off and heat sealing fabric piles, industrial tubings, profile gaskets.
- Car trim and upholstery, cutouts in instrument panels.
- Roof and wall insulation boards up to 125 mm thickness of foam PE, PS, PU. No gap, no cold bridge.
- Cutting out silicone gaskets for construction joints.
- Floor and wall claddings, including bituminous materials.
- Stress-free cutting of profile gaskets of PVC and Neoprene rubber for window and door frames.
- Clean cuts for subsequent welding or gluing.
- Electrical installations like conduit and trunking channels. Insulating cables and leads.
| Model DPM10 |
| Used for sheet plastics, asphalt roofing paper, roll stock and any high-heat application— Not designed for continuous use. |
| Blades |
Thickness |
Cutting Edge Length |
| DPM10* |
2.0 mm |
15 mm |
| *For use with the ZETZ24 only. |
|