Product Description
Insulation cutting 100mm blade
Choose the blade to suit the purpose. These blades are designed so that heat is concentrated along the cutting edge in order to achieve the optimum cutting temperature. Prior to insertion in the material to be cut, the temperature of the blades will be between 100°C and 800°C, depending on the type of blade and the thermocutter used. The temperature to the blade cools down as it enters the material. The temperature depends on the thermal properties and heat conductivity of the material being cut and determines the cutting speed. The cutting edge is evenly heated because of the design of the blade's cutting flanges.
Blades with model numbers in green are for use only with the ZETZ-24 and 25 Thermocutters.
- Suitable for thermoplastics with higher melting points such as rubber, synthetic rubber, synthetic resins
- Cutting rubber up to 90 Shore combustible, oil resistant rubber.
- Cutting out rubber linings on containers, mixers, vibration and, conveyor chutes and troughs.
- Angled cuts at joints on conveyor belts, camelbacks, rubber anti-abrasion coatings.
- Cutting and peeling rubber sectioning belts and flexible PVC (supported or unsupported).
Specialty Thermocutter Blades
| Blades |
Thickness |
Cutting Edge Length |
| DT 50 |
1.0 mm |
50 mm |
| DT 100 |
1.0 mm |
100 mm |
| DT 150 |
1.0 mm |
150 mm |
| DT 200 |
1.0 mm |
200 mm |
Blades for cutting insulating material. Thick blade for controlled cutting, with constant temperature along the cutting edge. Blades available in 7 lengths, should be chosen according to thickness of material. For a length of more than 100 mm, use only on ZETZ-24.
- For anyone using foam insulation such as contractors, painters, interior fitters, insulating specialists.
- Roof and wall insulation boards up to 200 mm thickness made of PE, PS, PU.
- Quick and neat joining and fitting of insulation boards. Cutting time for 1 m long, 150 thick insulation board is 8 seconds.
|